A fully symmetrical gain stage with high-quality complementary J-FET transistors in the input section.

The copper plates with a surface area of 350 mm2 installed in the Virtus S1S are designed for heat dissipation without the use of thermal washers, making the heat dissipation design of the power transistors extremely effective.

The copper plates designed for heat dissipation also supply the active components with voltage from the high-performance capacitors. This helps to transfer dynamic peaks directly from the capacitors to the loudspeakers and reduce output resistance.

• Extremely low distortion of 0.002%.
• Error correction is used to linearize each

amplifier stage individually. A local feedback loop is applied to correct the signal provided by the VAS oscillation stages. This helps to prevent transient distortion from the outset rather than relying on overall feedback to suppress it. Ideally, this leads to a weaker overall feedback circuit compared to one without error correction.

Virtus S1S features 5 pairs of output transistors per channel, the parameters of which are matched to ensure an even load on the individual components.

High damping factor and ultra-low output impedance.

Virtus S1S features power and signal sections that are mechanically shielded with a 10 mm thick aluminum screen.

Output power:
2 x 400 W / 4 Ω • 2 x 250 W / 8 Ω

Gain:
26 dB

Frequency response:
5 - 250,000 Hz – 3 dB / 5 W

Input impedance:
33 kΩ (RCA) • 100 kΩ (XLR)

Inputs:
2 x RCA, 2 x XLR

Harmonic distortion:
< 0.002% / 1 kHz, 5 W

Signal-to-noise ratio:
> 120 dB

Filter capacity:
107,600 uF / 100 V (per channel)

Trigger:
Yes

Input voltage:
230 V / 50 Hz / 1550 VA

Dimensions:
(W x H x D) 450 x 210 x 520 mm

Weight:
46 kg

Herstellerangaben:

CANOR, Ltd.
Družstevná 39
8006 , Prešov
Slovakia
sales@canor-audio.com

Verantwortliche Person:

IDC Klaassen International Distribution & Consulting oHG
22 Am Brambusch
44536 , Lünen
Germany
info@canor-audio.de